XT Mode Recovery Mode Normal Mode
Upgrade done by: PC/Management USB PC/Management USB/AT/WEB
An unsigned
package (lower
than 8.3 or with a
_U suffix)
XT <= 8.3.x: Accepted
XT >= 9.0: Not accepted
XT <= 8.3.x: Accepted
XT >= 9.0: Not accepted
6
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series on page 129.
Procedure
1. Access the remote download settings. From the endpoint's main menu, select
Administrator Settings > Utilities > Remote Access > Download. From the XT Series
web interface, select Configure > Advanced > Utilities > Remote Access > Download.
Figure 128: Enabling remote access to the XT Series
2. Set the fields as described in Table 57: Enabling remote upgrades on page 187.
Table 57: Enabling remote upgrades
Field Name Description
Download Management Select Yes to enable upgrades.
Enable All Addresses Select Yes to enable remote upgrades from any IP address. Select No
to restrict access from a specified range of addresses only, defined in
the Address and Subnet mask fields in this screen.
Addresses Specify the IP address allowed to upgrade this device remotely (only
relevant if you set the Enable all addresses field to No). This can
Table continues…
6
*By default, the unsigned software package is not accepted. You can force the system to accept an unsigned package
by setting “Verify Signature” to No.
Updating the XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 187
Comments on this document? infodev@avaya.com
To Next Page
Loading...
