From the endpoint interface
From the web interface
Figure 189: Configuring lip sync settings
2. Set the fields as described in Table 66: Configuring video quality settings on page 244
Table 66: Configuring video quality settings
Field Name Description
NetSense Set to Yes to enable NetSense.
NetSense is a proprietary Equinox Solution technology
which optimizes the video quality according to the available
bandwidth to minimize packet loss. As the available
bandwidth of a connection varies depending on data traffic,
NetSense's sophisticated algorithm dynamically scans the
video stream, and then reduces or improves the video
resolution to maximize quality with the available bandwidth.
Flow Control Set to Yes to send a Flow Control request to the remote
endpoint in case of packet loss. It attempts to reduce the
speed of data flow to prevent overwhelming one side with
too much data.
Lip-sync automatic Allows synchronizing audio with video. To have a perfect
synchronization between audio and video, you must adjust
according to the type of connection. If set to Yes, the
system will perform automatic synchronization (highly
recommended setting). If set to No, adjust manually by
dragging the Delay slider until you obtain the best
synchronization.
Delay Received audio delay in milliseconds. If Lip-sync
automatic is set to No, drag the slider until you obtain the
best synchronization.
Sharpness Select Yes to enable more definition or video sharpness
and alter the bandwidth required to maintain a video
resolution (see Setting Call Bandwidth in XT Series on
page 144). Select No to prefer more fluidity in motion.
Table continues…
Troubleshooting the Avaya Scopia
®
XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 244
Comments on this document? infodev@avaya.com
To Next Page
Loading...
