Field Name Description
• Sharpness: Select the when the displayed picture is
stationary.
Pairing Mode Select the pairing mode for Screen Link/Mobile Link:
• Disabled
• Enable - No PIN
• Enable - Ask PIN (Manual pairing)
• Enable - Ask PIN (Always)
9. Click Apply.
Equinox Management generates an endpoint service code to be used by the XT Series
endpoint. Furthermore, the endpoint details appear, where you enter an email address for
the user to receive notification that the endpoint has been pre-provisioned.
10. Select Send to send an email to the indicated user and open the All Endpoints page, or
select Skip to proceed directly to the All Endpoints page.
11. The endpoint is added to the All Endpoints table, with a blue ‘clock’ icon indicating that the
endpoint is pre-provisioned, and will receive the configuration after the insertion of the full
service code in the quick setup wizard at first start up. The ‘envelope’ icon enables you to
send a notification email to the specified user.
Figure 53: All Endpoints Table - Pre-provisioned Endpoint With Icon
Provisioning the XT Series
January 2017 Avaya Scopia
®
XT Series Deployment Guide 90
Comments on this document? infodev@avaya.com
To Next Page
Loading...
