Field Name Description
- Inform
- Show Status
When the Enable Encryption check box is not selected, the
Accepted Protected Calls option is enabled.
8. Expand the Advanced Settings section, and configure the relevant options:
Table 16: Advanced Settings Options
Field Name Description
Visible in the directory of
other endpoints (H.350–
enabled endpoints, desktop
and mobile)
Select to indicate that the endpoint is to appear in the directory of
H.350–enabled endpoints.
VIP Endpoint (experience will
not be downgraded during
call)
Select to assign the endpoint as a VIP endpoint without
diminishing call quality.
Has Embedded MCU Select to indicate that the endpoint has an embedded MCU.
SIP Server 1 The first SIP server through which the endpoint registers for
calls. It may be Equinox Management.
SIP Server 2 The second SIP server through which the endpoint registers for
calls. The endpoint uses this server if SIP Server 1 is not
available.
SIP Server 3 The third SIP server through which the endpoint registers for
calls. The endpoint uses this server if SIP Server 1 and SIP
Server 2 are not available.
SIP Username The username used to connect to the SIP server.
Authentication Name Enter a name used for authentication of the SIP server.
Authentication Password Enter the password used for authentication of the SIP server.
SIP Transport Type Select the protocol used by the SIP server:
• UDP
• TCP
• TLS
Max Bandwidth Select the maximum bandwidth of the endpoint.
Default Call Bandwidth (Kbps) Select the maximum bandwidth of the call managed by the
endpoint, measured in kilobytes per second (kbps).
MTU Size The size of the maximum transmission unit, measured in bytes.
Video Mode Select the video mode, according to the type of picture displayed
in the endpoint.
• Motion: Select when the displayed picture is in motion.
Table continues…
Provisioning Avaya Scopia
®
XT Series Endpoints Automatically
January 2017 Avaya Scopia
®
XT Series Deployment Guide 89
Comments on this document? infodev@avaya.com
To Next Page
Loading...
