3 — Operation
3 - 10 Service Instructions RP-A301CE/RP-A351CE/RP-A355CE
DANGER:
DO NOT TOUCH THE CARRIAGE
OR THE PRODUCT HOLDER
WHEN THE MACHINE IS
WORKING.
After completing the cutting operation,
press pushbutton to stop the product
holder. The blade remains in operation
whereas the product holder is fed to the
stroke end where it stops towards the
operator ready to start a new cutting cycle.
By pressing pushbutton to stop the
blade, the product holder stops in its
working position.
Manual operation
1. Rotate the carriage release handle in
a clockwise direction by 180.
2. Press pushbutton to start the
blade.
3. At constant speed feed the product
holder to the blade stroke end then
return to the operator and repeat the
operation.
To Next Page
Loading...