Universal Slave Driver
4
About This Guide
This guide assumes you understand the ba-
sics of synchronization and time code,
know how to operate devices that send or
receive time code such as a video tape re-
corder, and how to connect your studio.
Refer to the documentation for your studio
hardware if necessary.
In addition, you should have an under-
standing of the time code requirements for
your particular project.
Conventions Used in This Guide
Digidesign guides use the following con-
ventions to indicate menu choices and key
commands:
The following symbols are used to high-
light important information:
✽
User Tips
are helpful hints for getting the
most from your system.
✽
Important Notices
include information that
could affect your data or the performance of
your system.
✽
Cross References
point to related sections
in other Digidesign guides.
USD Synchronization
Support
Supported Positional Reference Sources
• LTC
• VITC
• Bi-Phase/Tach
• Internal Time Code Generator
• Serial Time Code (requires Digidesign’s
MachineControl option and Pro Tools
software version 5.0 or higher, and a
video reference signal)
Supported Clock Reference Sources
• Reference Video
• Composite Video Input
• Word Clock
• AES/EBU Null
• Pilot Tone
• Super Clock
• Internal Crystal
• Bi-phase/Tach
•LTC
Convention Action
File > Save Session Choose Save Session
from the File menu
Control+N Hold down the Control
key and press the
N
key
Option-click Hold down the Option
key and click the mouse
button
Right-click (Windows) Click with the right
mouse button
To Next Page
Loading...
