Chapter 3: Local Port Operation 29
Figure 3.12: Commands Dialog Box
3. Select Scan Enable in the Commands dialog box.
4. Click X to close the Commands dialog box.
NOTE: Scanning will begin as soon as the Scan Enable button is selected.
To cancel Scan mode:
Select a target device if the OSCAR interface is open.
-or-
Move the mouse or press any key on the keyboard if the OSCAR interface is not open. Scanning
will stop at the currently selected target device.
-or-
If the OSCAR interface is not open, press
Print Screen. The Main dialog box will appear.
a. Click Commands. The Commands dialog box appears.
b. Clear Scan Enable.
To Next Page
Loading...
