10
Item Description
WHITE BALANCE Process the current image to retain color balance over a color temperature range.
The options are: AUTO, 2500K, 3200K, 4200K, 5800K & 9500K.
SHARPNESS Sharpness enhances the clarity of image detail by adjusting the aperture and
sharpening the edges in the pictures.
Hold and drag the slider to adjust the level of sharpness. The higher the value, the
sharper the image.
SLOW SHUTTER Slow shutter is used to increase the exposure time to get clearer image, for example, at
night.
The options are: AUTO, 1/15 and 1/6.
IRIS IRIS is used to adjust the amount of light reaching the image sensor for best image
results. The options are: CLOSE, AUTO (default), OPEN, OFF
MIRROR Select “ON” to rotate the images horizontally based on your installation situation when
necessary.
FLIP Select “ON” to rotate the image 180° when necessary.
3D DENOISE Click and drag the slider to adjust the level from 0 ~ 5 to decrease the noise shown in
the dark environment.
3D denoise analyzes successive pictures to decrease the noise dramatically, but the
moving objects might be shown as blurred.
2D DENOISE Click and drag the slider to adjust the level from 0 ~ 5 to decrease the noise shown in
the dark environment.
2D denoise analyzes only a single picture to decrease the noise. The moving objects
can remain smooth edges, but the effect might be limited.
EXPOSURE VALUE Drag the slider to adjust the exposure level from 0 ~ 4.
WIDE DYNAMIC RANGE Wide Dynamic Range (WDR) is used when users need to increase image
recognizability in overexposure and dark areas.
The options are: LOW / MIDDLE / HIGH / OFF
FIXED SHUTTER Shutter Speed is a function that can adjust the duration of the electronic shutter to
produce optimum image quality. Select the shutter speed suitable for your
environment.
EFLIP This function is used to keep the image upright always after pan / tilt movement.
The options are: OFF / Mechanical.
DAY AND NIGHT This function is used to configure the day and night mode:
Day: Always stay in the day mode (color).
Night: Always stay in the night mode (B/W).
Sensor: Automatically switch based on the light sensor of the camera.
Digital Input N.O. (Used with Alarm In) Normally stay in the day mode, and switch to
the night mode when the alarm is triggered.
Digital Input N.C. (Used with Alarm In) Normally stay in the night mode, and switch to
the day mode the when alarm in triggered.
DEFOG Select “ON” to enable the defog function in poor weather conditions such as fog, smog
or smoke. The captured image can be improved.
MECHANICAL IRIS CALIBRATION Select “START” to begin mechanical iris calibration.
IR CONTROL Select “AUTO” to automatically enable IR LEDs at night or in the dark environment, or
“OFF” to disable this function.
IR TURN ON LEVEL Select the level for IR light to activate. 0 ~ 20
IR DELAY TIME Configure from 1 ~ 60 seconds to delay the switch of the IR mode at night.
This is used for the environment where the light condition may change suddenly and
usually last for a short time, for example, the entrance of a parking lot. It may cause the
day & night mode switching constantly and damage the camera.
With this function, the camera will delay the mode switch at night since the light change
is temporary and unnecessary to pay attention.
RESET DEFAULT Click to reset all camera settings to their default values.
REBOOT THE SYSTEM Click to reboot the camera if necessary.
To Next Page
Loading...
