13
3.3 SEQUENCE SETUP
Step1: On the DVR live view, click the channel with this speed dome camera connected. Then, click
on the bottom left side of the screen to show the PTZ control panel.
Step2: Click
to display the preset point panel, and click to go to the setting panel.
Step3: Click
/ to move to the point you want to configure as a preset point, and click the
numbering you want to appoint for this point. Then, wait till you see
(command sending)
appearing and disappearing on the DVR status bar.
NOTE: Up to 256 preset points could be configured.
Step4: Repeat Step3 until you’ve added all the points you need, or click to return to the Goto
panel.
Step5: In the Goto panel, select the numbering you’ve appointed for the preset points to check if they’re
working properly.
Step6: Return to the live view, and right click to show the main menu.
Select ADVANCED CONFIG DCCS. Then, select the channel which connects this camera,
and click SETUP to enter the menu of camera parameters.
ADVANCED CONFIG
C A M E R A CH1 CH2 CH3 CH4
DETECTION MENU SETUP
ALERT
NETWORK
DISPLAY
RECORD
DEVICES F.W. 1016
DCCS DEVICE AVTXXX
NOTIFY CONNECTION OK
EXIT
To Next Page
Loading...
Need help?
General
