14
Step6: Select CRUISE MODE, and choose SEQUENCE. Then, go to CRUISE CONFIG to select
SETUP.
SEQUENCE
ACTIVE NO: 1
ACTIVE TIME (MINUTES) 3
No1
PRESET DWELL TIME PAN SPEED
No2
01 No2
600
No7
No8
No9
No10
No11
No12
No13
No14
EXIT
ACTIVE TIME (MINUTES)
Select how long the area patrolling lasts in minute.
The options are 2, 3 and 5.
DWELL TIME
Select the time in second after which to move to the next point. The
time ranges from 3 to 60.
PAN SPEED
Select how fast to move the camera to the next point. The speed
ranges from 0 to 255.
Step6: Select EXIT, and right click to return to the live view.
Click the channel with this speed dome camera connected. Then, click
on the bottom left
side of the screen to show the PTZ control panel, and select
to start.
NOTE: To stop camera panning, click
again to escape.
To Next Page
Loading...
