Enable DDNS if needed.
Note: To enable the DDNS later, please go to “ADVANCED CONFIG” “NETWORK” “DDNS”
(“NETWORK” at page 35).
3.2 Clear Hard Disk
When this device is powered on, hard disk detection will be on, and you’ll be prompted to clear the hard disk(s):
CLEAR HDD
CLEAR HDD HDD0
Please choose “YES” to clear the connected hard disk(s), or this device will not detect hard disks properly for
video recording.
It might take some time to clear the connected hard disk(s). When it’s done, you’ll see the remaining hard disk
capacity on the top right corner of the screen.
Note: It’s necessary to clear hard disks in order to format the connected disks to the right format to save
video data. The format used for this device can NOT be read directly on a PC. Please do not install
the hard disk directly to a PC and try to copy the video data saved in the hard disk. The video data
might be impaired.
To change later, right click to show the main menu, and select (SYSTEM) “SYSTEM INFO” “CLEAR
HDD”. The DVR will reboot when hard disk data are cleared.
SYSTEM
ACCOUNT
BAUD RATE 2400
To Next Page
Loading...
Need help?
General
