Avtech DG1015 User Manual

APPENDIX 2 PUSH VIDEO CONFIGURATION
62
A2.2 Configuration
Before configuring Push Video, make sure:
1. The DVR system is set up as described in “2. CONNECTION AND SETUP” at page 4.
2. The DVR is connected to Internet.
3. You’ve installed the app, EagleEyes, on your iOS or Android mobile devices.
For details, please refer to “
7.2 Mobile Devices” at page 53.
Step1: Right click to show the main menu.
Go to (ADVANCED CONFIG.)  "NOTIFY”. In PUSH VIDEO, select the alarm device you want, and
configure the alarm type. For details, please refer to “PUSH VIDEO” at page 43.
ADVANCED CONFIG
CANERA
PUSH VIDEO
PUSH STATUS
MESSAGE MAIL
VIDEO MAIL VIDEO FTP
DETECTION
RESET ALL GUARD CONNECTION SUBMIT
ALERT
ALARM TRIGGERED DEVICE ALARM IN 1 
NETWORK
CH01 ALARM OFF / INTERNAL ALARM  CH1
DISPLAY
CH02 ALARM OFF  CH2
RECORD
CH03 ALARM N.O.  office
DCCS
CH04 ALARM OFF  CH4
NOTIFY
MULTICASTING
EXIT
Step2: Open EagleEyes, and add this DVR to the EagleEyes address book.
Step3: Enable Push Video as described below, and try to trigger your sensor to see if you can receive Push Video
successfully.

Avtech DG1015 Specifications

General

Brand	Avtech
Model	DG1015
Category	DVR
Language	English