AXIS 233D Installation Guide Page 21
ENGLISH
ENGLISH
Resetting to the Factory Default Settings
This will reset all parameters, including the IP address, to the Factory
Default settings:
1. Remove dome of camera.
2. Press and hold the red and black button at the same time. Release the red restart
button, but continue to hold down the black control button.
3. Keep the black control button pressed until the status indicator flashes amber (this
may take up to 15 seconds).
4. Release the black control button.
5. When the status indicator displays green (which can take up to 1 minute) the process
is complete and the camera has been reset to factory default.
6. Re-assign the IP address in the AXIS 233D using one of the methods described in this
document.
Further information
The user’s manual is available from the Axis Web site at www.axis.com or from the Axis
Network Video Product CD supplied with this product.
Tip!
Visit www.axis.com/techsup to check if there is updated firmware available for your
AXIS 233D. To see the currently installed firmware version, see the Basic
Configuration web page in the product’s Setup tools.
To Next Page
Loading...
Need help?
General
