52
AXIS 233D - System Options
Example: If the Normal state for a push button (such as a doorbell) connected to an input port is set to Open
circuit, the state is inactive as long as the button is not pushed. If the button is pushed, the state of
the input becomes active.
See also I/O terminal Connectors, on page 56.
Maintenance
Restart - The unit is restarted without changing any of the settings. Use this method if the
unit is not behaving as expected.
Restore - The unit is restarted and most current settings are reset to factory default values.
The settings that will not be reset are:
• the boot protocol (DHCP or static)
• the static IP address
• the default router
•the subnet mask
• the system time
Default - The default button should be used with caution. Pressing this will return all of
the network camera's settings to the factory default values (including the IP address).
Dome Status - Click the Test button to check the camera and dome mechanics for errors.
Contact Axis Customer Services if you receive an error message as the result of this test.
Upgrade Server - See Updating the Firmware, on page 60.
Backup - To take a backup of all parameters and any user-defined scripts, click this button
and save the backup file on the client computer. If necessary, it is possible to return to a
previous configuration if settings are changed and there is unexpected behavior.
Restore - Click the Browse button to locate the saved backup file (see above) and then
click the Restore button. The settings are restored to the previous configuration.
Note: Backup and Restore can only be used on the same unit running the same firmware. This feature is not
intended for multi-configurations or for firmware upgrades.
Support
Support Overview
This page provides information on Troubleshooting and Axis Support Services, should
you require technical assistance. When contacting your support channel, please provide
the Server Report available from this page.
To Next Page
Loading...
Need help?
General
