Axis 700 - The Parameter List; Parameter List Details

Appendix B: The Parameter List
AXIS 700 User’s Manual 55
Appendix B The Parameter List
Editing the
Parameter List
To edit the configuration parameters, you access the AXIS 700 from a
standard Web browser. Select Open Location and enter the URL of
the AXIS 700, i.e. the Internet address or the host name.
The List
This table shows the parameter list stored in the config file. The
middle column shows the default values, when applicable. The right-
hand column gives a brief description of the parameter.
Parameter name Value Description
[Server]
HardwareAddress = 00:40:8c:18:02:3c
The AXIS 700 hardware address. Default setting is the serial
number.
FactoryDefaults = no
Set this parameter to
yes
to reset to factory default settings.
Restart = no
Set this parameter to
yes
to restart the AXIS 700
[IP]
InternetAddress = 0.0.0.0
The AXIS 700 Internet address.
DefaultRouter = 0.0.0.0
All traffic directed outside the local network (according to the
NetMask) is sent to the default router. Any re-routing via other
routers is done automatically. The default
0.0.0.0
indicates that
no default router is set.
NetMask = 0.0.0.0
Used to determine when the traffic should be sent via a router.
For example the normal class C mask is 255.255.255.0. The
default 0.0.0.0 indicates that automatic router sensing is used.
BOOTPEnable = yes
Enables BOOTP Internet address setup.
RARPEnable = yes
Enables RARP Internet address setup.
DHCPEnable = yes
Enables DHCP Internet address setup.
DomainName =
Name of the domain to which the AXIS 700 belongs.
PrimaryDNS = 0.0.0.0
The Internet address of the primary DNS server. Used for
setting up of destinations with names instead of IP addresses.
SecondaryDNS = 0.0.0.0
The Internet address of the secondary DNS server, should the
primary be unavailable or disconnected.
[HTTP/FTP]
Password = pass
Password used when using HTTP or FTP to access the server.
BaseURL = www.axis.com/
Used for external links, e.g.
AXIS 700 support information.
.