Axis 700 - Front Panel Indicator Conditions

Appendix A: Troubleshooting
AXIS 700 User’s Manual 51
Using FTP
Follow these steps to restore the default settings using FTP:
1. Log in to the AXIS 700 with the command
ftp <host name>,
where
<host name>
is the name assigned in your system host
table or use its Internet address.
2. You will be prompted for user id and password. Use the user id
root
,
which has the default password
pass
(
root
is the user id with the
highest priority).
3. Issue the command
get defaults
to restore the default settings.
The unit will then automatically restart.
4. Log out using the command
quit
,
bye
or
exit
depending on your
FTP version.
The AXIS 700 will now restart with the factory default settings.
Front Panel Indicator Conditions
The Power LED is hardware controlled and should always remain lit
when power is connected to the AXIS 700. The remaining LEDs are
all software controlled.
Normal Conditions
This table shows the front panel indicators during normal conditions:
Event
Status
LED
Busy
LED
Network
LED
Remarks
Power up On On On Initial power to unit
Flash Off Off Self test in progress
Off Off Flash
Network LED flashes if network
traffic is present.
Scanning Off On Flash
Idle Off Off Flash
Network LED flashes if network
traffic is present.
Flash loading Off Blink Blink
During Flash loading, the
Network LED blinks quickly.