Axis P1344 User Manual

AXIS P1344 Network Camera
Accessing the product
Click the Emulate joystick mode button and click in the image to move the camera view in the direction of the
mouse pointer.
Click the Center mode button and click in the image to center the camera view on that position.
Click the Ctrl panel button to open the PTZ control panel w hich provides additional PTZ c ontrols.
User-defined buttons can also appear in the Control panel. See Controls, on page 28.
Pan and Tilt bars – Use the arrow s to pan and tilt the camera view, or click on a pos ition on the bar to steer the
camera view to that position.
Zoom bar – Use the arrows to zoom in and o ut, or click on a position on the bar to zoom to that position.
The PTZ controls can be disabled under PTZ > Advanced > Controls,seeControls, on page 28.
13

Axis P1344 Specifications

General

Video Compression	H.264, Motion JPEG
Optical Zoom	No
Digital Zoom	Yes
Video Compression Formats	H.264, Motion JPEG
Frame Rate	30 fps
Image Formats Supported	JPEG
Ethernet LAN	Yes
Memory Card Slot(s)	No
Sensor Type	CMOS
Day/Night	Yes
Power Over Ethernet	Yes
Ingress Protection	IP66
Field of View	80°
Power	PoE
Network Interface	Ethernet
Camera Type	Fixed
Sensor Size	1/4"
Minimum Illumination	0.5 lux
White Balance	Auto, Manual
Signal-to-Noise Ratio (SNR)	50 dB
Supported Resolutions	640x480, 320x240
Streaming Capability	Multiple, individually configurable streams
Network Protocols Supported	IPv4/v6, HTTP, HTTPS, FTP, SMTP, Bonjour, UPnP, SNMP, DNS, DynDNS, NTP, RTSP, RTP, TCP, UDP, IGMP, RTCP, ICMP, DHCP, ARP, SOCKS
Security Algorithms	HTTPS
Operating Temperature (T-T)	-10 °C to 50 °C
Aperture	F2.0
Operating Conditions	-10 °C to 50 °C
Storage Temperature	-20 °C to 60 °C