AXIS P3301 Fixed Dome Network Camera
System Options
To change the date and time settings, select the p referred Time mode under New Server Time:
• Synchronize w ith computer time sets date and time according to the computer’s clock. With this option, date and
time are set once and will not be updated automatically.
• Synchronize with NTP Server obtains date and time from an NTP server. With this option, date and time settings are
updated continuously. For information on NTP settings, see NTP Configuration, on page 34.
If using a host name for the NTP server, a DNS server must be configured. See DNS Configuration, on page 34.
• Set manually allows you to manually set date and time.
If using an NTP server, select your Time zone from the drop-down list. If required, check Automatically adjust for daylight saving
time changes.
The Date & Time Format Used in Images is the date and time format displayed as a text overlay in the video stream. Use the
predefined formats or see File Naming & Date/Time Formats in the o nline h e lp
for information on how to create custom date and
time formats. T o include date and time in the overlay text, go to Video & Audio and sele ct Include date and Include time.
Network
Basic TCP/IP Settings
The Axis product supports IP version 4 and IP v ersion 6. Both versions can be enabled simultaneo usly, and at least one version
must always be enabled.
IPv4 Address Configuration
By default, the Axis p roduct is set to use IPv4 (IP version 4) and to obtain the IP address automatically via DHCP. The IPv4 settings are
configured under System Options > Network > TCP/IP > Basic.
DHCP (Dynamic Host Configuration Protocol) allows network administrators to centrally manage and a utomate the assignment of IP
addresses. DHCP should only be enabled if using dynamic IP address notification,oriftheDHCPcanupdateaDNSserver,which
when allows you to access the Axis product by name (host name).
If DHCP is e n abl ed and the product cannot be accessed, run AXIS IP Utility to se arch the network f or connected Axis products, or reset
the product to the factory default settings (see page 40) and then perform the installation again.
To use a static IP address, check Use the following IP address and specify the IP address, subnet mask and default router.
IPv6 Address Configuration
If IPv6 (IP version 6) is enable d, the Axis product will receive an IP address according to the configuration in the network router.
To enable IPv6, go to System Options > Network > TCP/IP > Basic. Other settings for IPv6 should be configured in the network router.
ARP/Ping
The IP address can be set using ARP and Ping. For instructions, see the product’s Installation Guide.
ARP/Ping is enabled by d efault. To disable, uncheck the box under System Options > Network > TCP/IP > Basic.
The A RP/Ping service is au tomatically disabled two minutes after the product is started, or as soon as an IP address is set. To reset the
IP address, the product must be restarted to activate ARP/Ping for an additional two minutes.
Pinging the product is still possible when this service is disabled.
33
To Next Page
Loading...
Need help?
General
