AXIS P3301 Fixed Dome Network Camera
System Options
To clear all recor dings and data from the Axis product’s folder on the d es ignated share, click Clear under Storage Tools.
To avoid filling the share, it is recommended to remove recordings continuously. U nder Recording Settings,selectRemove recordings
older than and select the number of days or weeks.
To stop writing to the share and protect recordings from being removed, select Lock under Recording Settings.
Ports & Devices
I/O Ports
The Axis product provides one input port and one output port for connection of exte rna l devices. For information on how to
connect external devices, see Connectors, on page 4 .
The I/O ports are configured under System Options > Ports & Devices > I/O Ports. The ports can be given descriptive names and their
Normal states can be configured as Open circuit or Grounded circuit.
Port Status
The list on the System Options > Ports & Devices > Port Status page shows the status of the product’s input and output ports.
Maintenance
The Axis product provides several maintenance functions. These are available under System Options > Maintenance.
Click Restart to perform a correct restart if the Axis product is not behaving as expected. This will not affect any of the current
settings.
Click Restore to reset most settings to the factory default values. The following settings are not affected:
• the boot protocol (DHCP or static)
• the static IP address
• the default router
• the subnet mask
•thesystemtime
• the IEEE 802.1X settings
• the focus position
Click Default to reset all settings, including the IP address, to the factory default v alues. This button should be used with caution. The
Axis product can also be reset to factory default using the contro l button, see Reset to factory default settings, on page 40.
To identify the p roduct or test the Status LED, click Flash LED under Identify and specify the duration in seconds, minutes or hours.
Th
is can be useful for identifying the product among othe r products installe d in the same location.
For information about firmware upgrade, see Upgrading the firmware, on page 41.
Support
Support Overview
The System Options > Support > Support Overview page provides information on troubleshooting and contact information,
should you require technical assistance.
See also Troubleshooting, on page 41.
38
To Next Page
Loading...
Need help?
General
