5-6
Chapter 5. ADVANCED OPERATION
5 - 2 Parameter Setup
Setup method
Follow the procedure below to set the parameters such as flowrate deviation alarm
upper and lower limit flowrate and event output delay time.
(1) Press the [DISP] key to display the integrated flowrate.
>>
"L" lamp lights.
(2) Keep the [
] key pressed for 3 seconds.
>>
"0.r G" is indicated on the upper display. (Parameter setup mode).
(3) Press the [
] key or [v] key to select the target setup item, and press the [ENT]
key.
>>
The setting value currently being indicated on the lower display blinks.
(4) Press the [
] key or [v] key to select the target setting value. You can move to
the digit to be changed by pressing the [ ] key.
(5) When the target setting value is displayed, press the [ENT] key to fix the setting
value.
>>
The setting value is stored.
If other items are required to set up, return to the step (3) and repeat the procedure.
Otherwise, proceed to the step (6).
(6) Press the [DISP] key.
>>The mode is returned to the instantaneous flowrate display.
Handling Precautions
• If you do nothing for one minute after entering the parameter setup mode,
the display automatically returns to the regular (instantaneous PV) display.
• If you press the [DISP] key without pressing the [ENT] key after carrying out
the operation in step (5), the setting remains at the previous value without
being updated.
To Next Page
Loading...
Need help?
General
