User Manual
Page 19 of 52
This page easily allows you to determine or set parameters for the following:
Connection Status. Displays the model of your router, the Basic MAC
Address, its Serial No., and your router’s Firmware Version.
Connection Method.
Allows you to set your router’s method of
connection. By default the Connection Method is set to ‘
Auto
’. This
default setting allows your router to automatically detect active
connections on your router’s Ethernet WAN and DSL port.
NOTE: You may change the connection method, however, it is strongly
advised to leave the Connection Method as AUTO.
To change the connection method:
1. Select the preferred connection method.
2. Click the Save button to apply changes.
3. Refresh page for the Service Provider selection list to update.
Service Provider. This function directly corresponds to your Connection
Method. After selecting a connection method, a selection list would be
available on the Service Provider’s drop down menu. By default, the
Service Provider drop down menu corresponds to the ‘Auto’
Connection Method.
To Next Page
Loading...
Need help?
General
