Azure Imaging System User Manual Page 23
5. Settings Overview
You can reach the Settings at any time by clicking .
5.1 General
• Dye List – shows a full list of all dyes currently programmed into the system. Add dyes to the
list by entering a Channel Name, selecting the Light Source and Emission Filter, selecting the
Sample Type(s) and pressing Add.
• File Saving – settings allows you to enable the automatic saving of 8-Bit publication images.
Note: Publication images are for publication and printing purposes only and should not be
used for data analysis.
• Chemi Imaging Mode – allows you to select the number of images in cumulative. The default is 10.
• Check Auto Merge Chemi and Marker Image – image to enable automatic merging of chemi and
color marker images upon capture.
• Auto-Exposure
• Rapid capture – will calculate an optimal exposure time based on the signal ceiling entered set
here. The ceiling range is 0 to 65,535.
• Simulation Mode – allows you to run the software even if not connected to an Azure Imaging
System.
5.2 Create Darkmasters, Focus Calibration, Create Flats
Darkmasters, Focus Calibration and Flats are set at the time of manufacture. If you require
assistance with any of these settings, please contact Azure Biosystems Technical Support at
support@azurebiosystems.com.
To Next Page
Loading...
