24 | Wiring the Zeus Display
H-Link
H-Link is B&G’s protocol for comprehensive and efficient interfacing of the B&G H3000
processor range used in conjunction with Zeus chartplotters and external PC navigation
programmes.
There are two versions of H-Link depending on the H3000 processor you are using.
B&G H-Link LT
H-Link LT is a version of the B&G data communication protocol providing an interface to
Zeus displays. This allows high speed two way data communications and access to True
Wind Calibration tables. H-Link LT is available on H3000 Hydra and Hercules CPUs.
Polar data is not available on H3000 Hydra and H3000 Hercules Processors.
B&G H-Link Pro
H-Link Pro is the full version of the B&G data communication protocol, it is available on
H3000 Hercules Performance and H3000 Hercules Motion CPUs.
H-Link Pro provides a full instrument interface with the Zeus Display. In addition to the
high speed two way data communications and access to the True Wind Correction Tables,
H-Link Pro will allow the full use of the Polar features in Zeus, and will allow you to
display Target speed and Target Angle information.
To Next Page
Loading...
General