8 Instrument Care
© b2 electronic GmbH DHV0017 b2 EN 45
8.4 Charging Internal Battery
Once the AC power supply is connected the integrated battery will
automatically begin charging when the unit is turned on.
1. Connect an AC power supply (according to the procedure
indicated in the Section “Test Procedure”)
2. The BA unit starts automatically
3. The display indicates that the battery is charged.
4. After 20 seconds the unit turn into “Power-Save-Mode”.
5. To start the unit, use “PowerOn Button”.
8.5 Storage/Repairs
Storage
Maintenance and Repairs
NOTICE
With a DC power supply connected, the integrated battery will not charge.
NOTICE
Do not store the BA test equipment outdoors!
The storage temperature must comply with the temperature range
specified in section “Technical Data”.
NOTICE
Repairs and maintenance should only be preformed by authorized
b2 personnel.
To Next Page
Loading...
