MODEL 300 COMBUSTION ANALYZER
TABLE OF CONTENTS
ii Instruction 24-9223
1 INTRODUCTION ................................................................................ 1-1
1.1 Scope of Manual .......................................................................... 1-1
1.2 Basic Features ............................................................................. 1-2
1.3 Optional Features ....................................................................... 1-3
1.4 Basic Panel Functions & Displays .............................................. 1-4
1.4.1 CAL, FUEL, and RUN Keys ............................................ 1-4
1.4.2 Left Display and Select Key ........................................... 1-5
1.4.3 Middle Display and Select Key ........................................ 1-7
1.4.4 Right Display and Select Key .......................................... 1-8
1.5 Optional Auxiliary Panel Functions & Displays ........................ 1-9
1.5.1 Left Display - Clock .......................................................... 1-9
1.5.2 Middle Display - ppm NOX.............................................. 1-9
1.5.3 Right Display - ppm SO2 ................................................. 1-9
2 SET-UP ................................................................................................. 2-1
2.1 230 VAC Plug Installation .......................................................... 2-2
2.2 Printer Paper Installation .......................................................... 2-2
2.3 Filter/Trap Installation ............................................................... 2-2
2.4 Probe Connection ........................................................................ 2-3
2.5 Initial Start-up and Adjustment ................................................. 2-4
2.6 Sensor Checks ............................................................................. 2-7
2.7 Optional Clock Setting ................................................................ 2-8
2.8 Optional Analyzer Configuration ............................................. 2-10
3 OPERATION ........................................................................................ 3-1
3.1 Performing an Efficiency Test .................................................... 3-3
3.2 Gas Sampling Points ................................................................... 3-6
3.3 Installing the Probe ..................................................................... 3-6
3.4 Printer Operation ........................................................................ 3-7
3.5 Error, Warning and Overrange Displays ................................... 3-9
3.5.1 Basic Error, Warning and Overrange Displays .............. 3-9
3.5.2 Optional Error, Warning, and Overrange Displays ..... 3-10
3.6 Recalibration after an Efficiency Test ...................................... 3-14
3.7 Changing Fuels ......................................................................... 3-15
3.8 Combustion Analyzer Shutdown and Storage ......................... 3-15
3.9 Charging the Battery Pack ....................................................... 3-18
To Next Page
Loading...
Need help?
General
