MZ-RD – Multi-Zone Remote Display
Instruction 3015-5157 3
CHAPTER 2. INSTALLATION
2.1. Warnings and Cautions
WARNING: Explosion hazard! Do not mount the MZ-RD in an area that may contain
flammable liquids, vapors or aerosols. Operation of any electrical equipment in such an
environment constitutes a safety hazard.
WARNING: Electrical installation should be performed by a certified electrician, and
should comply with all applicable NEC/CEC and local electrical safety codes.
WARNING: The AC power ground wire must first be connected to the monitor’s ground
stud. Under no circumstances should this monitor be operated without a protective
ground. Doing so poses a potential shock hazard, and is also a violation of electrical safety
standards applicable to this type of equipment.
WARNING: Shock hazard! Always disconnect AC power before working inside the
monitor.
CAUTION: Drilling holes in the MZ-RD enclosure may damage the unit and will void the
warranty. Please use provided knockouts for electrical connections.
CAUTION: The MZ-RD contains sensitive electronic components that can be easily
damaged. Be careful not to touch or disturb any of these components.
2.2. Preliminary Inspection
The MZ-RD has been thoroughly inspected and tested prior to shipment from the factory. Nevertheless,
it is recommended that the instrument be re-checked prior to installation. Inspect the outside of the
enclosure to make sure there are no obvious signs of shipping damage. Loosen the four screws on the
sides of the enclosure and remove the front panel. Visually inspect the interior of the displ
ay for loose
components that may have become dislodged during shipment. If damage is discovered, please contact
the nearest Bacharach Service Center for assistance.
2.3. Location of the Remote Display
To Next Page
Loading...
Need help?
General
