Bad Boy 1500 - Float Chamber

PAGE 47
Float Chamber:
• Remove main jet, needle jet holder, needle jet, slow jet, and air adjustment screw.
CAUTION
• Be very careful not to damage jets or adjust screw.
• Before removing adjustment screw, turn it all the way down and note the number of turns.
• Do not turn adjust screw forcefully to avoid damaging valve seat face.
Assembly
• Install main jet, needle jet holder, needle jet, slow jet and air adjustment screw.
• Install the float valve, float, and float pin.
CAUTION
• Set the air adjustment screw in according to number of turns noted before it was removed.
Main Jet Adapter