PAGE 92
SERVICE MANUAL
Alternator/Starting Clutch
• Install starting driven
gear.
Flywheel Installation:
• Align the key on
crankshaft with the
flywheel groove,
and then install the
flywheel.
• Hold the flywheel
by drive face with
universal holder, and
tighten flywheel nut.
• Flywheel nut not to
be reused. Nut should
be replaced when
disassembled.
• Torque value: 85 ft/lbs
• Special tool: Universal Holder
• Install reduction gear
shaft and reduction
gear.
A.C.G. Set Installation:
• Install the A.C.G.
coil set onto right
crankcase cover
(3 screws).
• Install pulse
generator (3
screws).
• Tie the wire
harness securely
onto the indent
of crankcase.
Left Crankcase
Cover Installation:
• Install dowel pin
and new gasket.
• Install left
crankcase
cover onto the
crankcase.
Note:
Align the water
pump shaft indent
with the water
pump gear shaft.
• Install left crankcase cover (15 screws).
• Install the dowel pin, new gasket and water pump
cover onto left crankcase cover.
To Next Page
Loading...
