Actions
● Press the enter button to stop the Base.
● Press the back button to return to the Base status
page - Base remains active
When a Base session is started, a RINEX file recording
occurs automatically. This RINEX file may be used to
establish an updated reference point in the future or confirm
the known point used.
A recording of less than 15 minutes may not contain enough
data to reliably post-correct. If you don’t plan to use this data it
is safe to cancel Base operation by clicking the enter button
to stop the Base.
Should you require this additional recording, simply press the
back button to return to the Base status page and let
more than 15 minutes elapse on the duration since start.
To Next Page
Loading...
