Need help?Do you have a question about the Bad Elf Flex and is the answer not in the manual?
General| Channels | 184 |
|---|---|
| Ports | USB-C |
| Waterproof | IP67 |
| Category | GNSS Receiver |
| GPS Chipset | u-blox ZED-F9P |
| GNSS | GPS, GLONASS, Galileo, QZSS, BeiDou |
| Update Rate | 10 Hz |
| Connectivity | Bluetooth, USB |
| Operating Temperature | -20°C to 60°C |
| SBAS | WAAS, EGNOS, MSAS, GAGAN |
How to configure the Flex for rover mode using the device's LCD.
How to navigate through the rover feature menus.
Explains the need for a Flex token for extreme mode.
Checks for radio connection and pairing status.
The device listens for incoming correction data from the base.
Confirmation that a base has been detected and a corrections feed is available.
Steps to initiate stopping the rover function.
Details on the main rover status information displayed.
Clarifies that tokens are not required for the checklist, but for entering Rover mode.
How to adjust the pole height value within the checklist.
Configuring the Flex for base mode without an app.
How to navigate the user interface for base operations.
Selecting the correction mode for base operation.
The device searches for the Harxon radio for base setup.
Verifying the pole height for the base configuration.
Performing a tilt calibration for the base.
Navigating the app to select the 'Base Mode'.
Details the initial setup steps in the base checklist.
To Next Page
