Bad Elf Flex - Establishing Base Reference Point; Base Reference Point - Capture; Base Reference Point

To Next Page

To Previous Page

Establishing Base Reference Point

For the Flex Base to operate properly, a reference point must

be established for the transmission of corrections. The

reference point must be within ??ft/??m or an error condition

occurs and the Base cannot start.

There are three options to establish a Base reference point.

1. Here point - this is a position derived from the current

GNSS location and mode of operation

2. Last collected point - this is a position derived from the

last collected point through the use of the standalone

point collection feature of Flex

3. Known point - a list of known points is provided, if

available. Known points are loaded into the Flex app

by ????

Base Reference Point - Capture

The default method used to establish a base reference point

is a “Here” point. Pressing the “Capture” button starts a timed

point recording.

Base Reference Point - Established

Once the Base reference point is established, the coordinates

and results are displayed for confirmation.

note : obscure the location

Using a Known Base Reference Point

Bad Elf Flex - Establishing Base Reference Point; Base Reference Point - Capture; Base Reference Point - Established