Operating Manual BaehrTec A1200 / A2000
English – V100 - Date 09/2017 Page 11/64
• Only use high-quality rotating instruments with standardised shaft (diameter 2.35 mm)
from the Baehr product range.
• Please observe the specific instructions of rotating instruments when using them. Above
all, observe the manufacturer's information on maximum speeds, cleaning, disinfection
and sterilisation.
• Disinfect, clean and sterilise the instruments after each use.
• Only use cleaned, disinfected and sterilised instruments for each change of patient to
avoid a possible transfer of germs to the next patient.
• Disinfect the handpiece after each use and before each change of patient. (Please
ensure that no disinfecting agent or other liquid can enter the device).
• Disinfect all parts of the device that could have come into contact with contaminated
patients after each use and before each change of patient. (Please ensure that no
disinfecting agent or other liquid can enter the device).
• The operating staff must wear protective gloves as well as eye, mouth and nose
protection when using the device.
• When using the device, the staff must take care that neither hair nor any other loose
objects such as wipes, cotton wool or the like can enter the area of the rotating tools. A
hair net must be worn where necessary.
• The operating staff must bear in mind that the particles that are removed when working
with the rotating tools may chip. Open and untreated wounds on the patient which are
in the direct vicinity of the working area should therefore be covered in a sterile way in
order to protect them from any splintering particles.
• The device must be maintained and cleaned according to the instructions before and
after long pauses in use.
• Only accessories authorised for use with the device may be used.
• The national statutory provisions must be observed during use, in particular:
the currently applicable work regulations
the currently applicable accident prevention measures
To guarantee constant readiness for operation and preservation of value, the prescribed care
work and maintenance services must be performed.
The device must only be repaired using replacement parts approved by the manufacturer and
in accordance with the manufacturer’s instructions. The recommended maintenance services
(after notification, but at the latest within 24 months) and inspection and repair work must only
be performed by the manufacturer.
This device must not be modified without the permission of the manufacturer.
To Next Page
Loading...