Baehr BaehrTec A1200 - Changing the Filter

Operating Manual BaehrTec A1200 / A2000
English – V100 - Date 09/2017 Page 35/64
Connecting Fig. 15
When changing the dust bag, make sure that the dust bag does not pinch
between the controller and the dust bag lid. If this should be the case,
remove the dust bag lid once again and make sure that the dust bag is not
pinched when closing.
Before you close the dust bag lid and resume your work, always make sure
that the turbine protection filter (rectangular) is inserted and that you have
attached an undamaged dust bag correctly in the receptacle (39) for the dust
bag (42), so that no impurities can enter the turbine and damage the device.
4.9 Changing the filter
We recommend changing the dust bag, as well as all filters regularly and at
least every four weeks, in order to prevent excessive germ build-up. Think
of your health!
Before we describe how to change the filter, we would like to provide you with some quick
information on the filtration system in the BaehrTec A1200/A2000.
1. Filter: Dust bag
This filter has been proven in many suction systems to this day. It filters out the majority of
dust particles. It is affordable, not too large, and must therefore be changed more often than
a large dust bag. This has the great advantage that you do not have a build-up of organic
dust and pathogens in your filter system for too long. The dust bag is located in the
suction chamber on the receptacle (39) for the dust bag (42).
If you need additional dust bags, you can order microfibre dust bags (Art No. 21185) like those
contained in the delivery.
2. Filter: Turbine protection filter
This filter prevents larger parts entering the turbines (e.g. if you have forgotten to install a dust
bag). The turbine protection filter is located in the filter chamber on the grille.