Operating Manual BaehrTec A1200 / A2000
English – V100 - Date 09/2017 Page 29/64
Here, ready for operation does not necessarily mean that the suction is actually active, as the
suction only becomes active when the suction is ready for operation and the handpiece motor
is also in operation.
If the suction is actually active, this will be indicated on the display by two additional symbols.
This symbol is displayed if the suction is not currently in operation with the
suction level you have set (suction off).
This symbol is displayed if the suction is not currently in operation with the
suction level you have set (suction on).
(Can only appear while the handpiece motor is running).
Therefore, the following situations are possible:
Handpiece motor
Suction
ready for use
Bar diagram
on the display
Suction
Off No Transparent Off
This offers you the following advantage:
If you set the suction so that it is "not ready for operation", you can see which
suction level you last selected at all times. If you then want to set the suction
in the same way, all you need to do is simply press button (20) and the
suction will be ready for operation again.
As soon as you press one of the suction level buttons (21) – (26), (27) or
(28), this suction level will immediately be set and will also immediately be
"ready for use". This means you only ever have to press one button.
To Next Page
Loading...