BAFANG M625 - Page 23

USER MANUAL – M625/M325 DRIVE SYSTEM
22
8.7.1.2 “Service” Switching the notification
on and off
Press the
or (<0.5S) button to high-
light “Service” in the display settings menu,
and then press (<0.5S) to select. Then
with the or button choose between
“ON” or “OFF”. Once you have chosen your
desired selection, press the (<0.5S) but-
ton to save and exit to the "Display Setting"
interface.
8.7.1.3 “Brightness” Display brightness
Press the
or (<0.5S) button to
highlight “Brightness” in the display settings
menu. Then press (<0.5S) to select. Then
with the or button choose between
"100%" / "75%" / "50%" /" 30%"/"10%" .
Once you have chosen your desired selec-
tion, press the (<0.5S) button to save
and exit to the "Display Setting" interface.
8.7.1.4 “Auto Off” Set Automatic system
switch off time
Press the
or (<0.5S) button to high-
light “Auto Off” in the display settings menu,
and then press (<0.5S) to select. Then
with the or button choose between
“OFF”, "9"/"8"/"7"/"6"/"5"/"4"/"3" /"2"/"1",
(The numbers are measured in minutes).
Once you have chosen your desired selec-
tion, press the (<0.5S) button to save
and exit to the "Display Setting" interface.
8.7.1.5 “Default Mode”
Press the
or (<0.5S) button to high-
light “Default Mode” in the display settings
menu, and then press (<0.5S) to select.
Then with the or button choose
between “ECO/SPORT”. Once you have
chosen your desired selection, press the
(<0.5S) button to save and exit to the
"Display Setting"
8.7.1.6 “Power View” Setting the power
indicator
Press the
or (<0.5S) button to high-
light “Power View” in the display settings
menu, and then press (<0.5S) to select.
Then with the or button choose
between “Power” or “Current”. Once you
have chosen your desired selection, press
the (<0.5S) button to save and exit to
the "Display Setting" interface.
8.7.1.7 “SOC View” Battery view in volt
percent
Press the
or (<0.5S) button to
highlight “SOC View” in the display settings
menu, and then press (<0.5S) to select.
Then with the or button choose
between “percent” or “voltage “. Once you
have chosen your desired selection, press
the (<0.5S) button to save and exit to
the "Display Setting"