100 Open and close
D50
2
Operation System and Specification
Lifting ventilation on/off
The start/stop button is in "RUN" Mode. When
the sunroof is in the closed state, long press or
touch the "TILT UP" button, and the rear part of
the sunroof glass rises and warps to the open
position and automatically stops. In the warping
process, press the sunroof control button, and
the sunroof glass will stop at the current
position.
The start/stop button is in "RUN" mode. Long
press the "SLIDE OPEN" button to close the
sunroof, which has no clamp-proof function in
this process. (If the "SLIDE OPEN" button is
touched, the sunroof glass has the function of
anti-clip during closing).
Sunroof manual initialization and self –
learning
In some cases (after a sudden loss of battery
power or prolonged parking of the vehicle),
manual sunroof initialization may be required.
The specific operations are as follows:
1. Within 5 seconds, switch the start/stop button
to "RUN" mode, then close it, and then switch
to "RUN" mode
2. Within 5 seconds after the first step, long
press the sunroof "TILT UP" button and keep it,
and the sunroof glass becomes warped
completely. Upon hearing the sound of "click",
the sunroof glass will be operated as follows:
fully open- fully close-fully open; after this
process is completed, the sunroof stops running,
release the button, and the sunroof glass
initialization process is completed.
If the sunroof initialization fails, it needs to be
reinitialized according to the above steps.
。
Sunroof visor
The sunshade can be opened with the sunroof,
but manually pull the sunshade back to close
when closed
Notice
●When the sunroof is open, do not
forcibly close the sunshade.
To Next Page
Loading...
Need help?
General
