208 Tires and wheels
D50
4
Maintenance
When rotating tires, be sure to follow the correct
rotation mode as shown in the diagram. Do not
use the compact spare tire when rotating tires.
After rotating tires, ensure that all wheel nuts
have been tightened to 110±10N·m. And adjust
the air pressure of all the tires to the set value.
After the vehicle has traveled 1000km, re-check
the wheel nut fastening.
Warning
●Rusting or dirt on the wheels or wheel
connectors will cause the loosening of the
lug nuts after a certain period of time,
thus resulting in the falling-off of wheels
and traffic accidents. Therefore when
replacing wheels, it is necessary to clear
any rust or dirt on the wheels and their
Wheel Balance
Before the vehicle left the factory, the wheels
already underwent dynamic balance treatment.
However, many factors in the vehicle use
process will affect wheel balance, thus resulting
in wheel imbalance.
Be sure to promptly perform dynamic balance
treatment on imbalanced wheels.
Otherwise, will cause excessive wear to the
steering system, the suspension system and tires.
After tires are replaced,
The wheels must be dynamically balanced
again.
Dynamic balance standard for wheels:
Initial unbalance value ≤60g,
（
Single side
）
Residual unbalance value ≤8g.
（
Single side
）
Selection and replacement of tires
Buy New Tires
View the tire and loading information label on
the vehicle to get information on the model and
dimension of the tires needed.
Tires of the same brand, specification, size,
pattern and condition must be used on the same
axle.
To Next Page
Loading...
Need help?
General
