134 Start and driving
D50
3
Driving guide
Start and driving
Notice of running-in
In order to improve the service life of the
vehicle, the new car in the early use should be
running-in, can be used normally. The following
is the run-in period:
●The running in period is 1500km.
●Choose better roads and drive light.
●Do not exceed 80% of the maximum speed
●Do not press the accelerator pedal to the
bottom for rapid acceleration.
●Avoid emergency braking for the first 300km.
Strictly follow operating procedures and
maintain normal engine operating temperature.
●Do the daily maintenance work of the vehicle
carefully, check frequently, pay attention to the
sound and temperature changes of each
assembly in operation.
Running-in engine
The engine can prolong the service life and
reduce the oil consumption. The new engine
must go through 1500km of running in, and
during the running in period, the following
regulations must be observed:
●Avoid high speed engine running, do not
exceed 80% of the maximum speed.
●Do not tow other vehicles.
At 1000-1500km, the engine speed and speed
can be gradually increased to the maximum
permissible range.
At the beginning of run-in, the internal friction
resistance of the engine is much greater than
after run-in, oil consumption may be higher than
normal, you should check the engine oil
regularly.
All the moving parts of the engine can achieve
the best fit after running in.
Running in tires and brake
Drive at a moderate speed for the first 500km,
running the new tires well.
If the new brake liner and brake disc cannot
reach the optimal friction state within the initial
300km, emergency braking should be avoided
and sufficient safe braking distance should be
maintained.
To Next Page
Loading...
Need help?
General
