Tires and wheels 211
D50
4
Maintenance
Replacement of the Rim
Bent, cracked or seriously rusting or corroded
rims should be replaced. Wheels that leak
should be replaced (except for some repairable
aluminum wheels).
The new rim should have the same load capacity,
diameter, width and alignment as those of the
original wheels. The new rim should also be
mounted identically as the original wheels.
Warning
●Use of an unsuitable rim will be very
dangerous. It will affect the braking and
steering performance of the vehicle,
resulting in tire leakage and making the
vehicle run out of control. It may cause
accidents, injuring you or others.
● Use of the wrong rim will also cause
problems to the life of the bearing, the
cooling of the brake, the calibration of the
speedometer or odometer, the focusing of
the headlights, the height of the bumper,
the ground clearance of the vehicle, and
the clearance between the tires or tire
chain and the vehicle body and chassis,
etc.
● Use of a used rim on the vehicle can be
very dangerous. There is no way for you
to know how the used rim has been used
or how many miles it has been driven.
Such rims may suddenly break down and
cause an accident. If you need to replace
rims, be sure to use BAIC’s new and
original rims.
Nonskid Chains
Do NOT mount any nonskid chain which is not
consented by BAIC. Nonskid chains not suitable
for the snow ground will damage the tires, rims,
suspension, brake, and body of the vehicle. In
the use of nonskid chains, pay attention to the
following requirements:
● Nonskid chains can only be mounted on the
front wheels;
● Follow the tightening instructions for the
mounting of nonskid chains and the vehicle
speed limits under various road conditions;
●To avoid damage to tires and the excessive
wear of nonskid chain, when driving on
snow-free road surfaces, be sure to remove the
nonskid chain.
To Next Page
Loading...
Need help?
General
