222 Defective wheel replacement
D50
5
Emergency handling
Notice
● The rim and tire dimensions of the
spare wheel may differ from the damaged
wheel. When the spare wheel is installed,
the vehicle's handling will change. Please
co
ntrol the speed reasonably to avoid
rapid acceleration and emergency
braking.
● spare wheels can only be used for short
periods of time. The maximum speed
should not exceed 70km/h.
●It's not allowed to use 2 or more spare
wheels during driving.
Preparation
If found tire burst, puncture, bulge, air leakage
and other phenomena, should slowly drive to a
flat and safe place to replace the spare wheel, so
as to avoid further damage to tires and rims. At
the same time, turn on the hazard warning light
and place the triangle warning sign at the
specified distance behind the car.
Warning
● Wheel replacement is dangerous and
can cause serious injury or death when
the vehicle slides off the jack assembly,
tips over and falls on the operator or
other person. Replace wheels on safe, flat,
solid ground. All passengers must leave
the vehicle and wait in a safety area.
To prevent vehicle movement, the
following measures should be taken:
● apply parking brake.
● put the shift level at the "P"
position.(automatic transmission model)
● turn off the engine, do not start the
engine in the process of lifting the vehicle.
● do not leave anyone in the car.
Remove the damaged wheel.
1. Place appropriate blocks in front and behind
the wheels diagonally opposite to the defective
wheels to prevent movement of the vehicle
during jacking.
2. Place the jack assembly at the correct support
point. Be sure to place the jack assembly on a
flat, firm ground
。
To Next Page
Loading...
Need help?
General
