152 Brake system
D50
3
Driving guide
Parking brake system (mechanical
brake type)*
The parking brake control handle is tightened
upward, that is, the parking brake is
implemented, and the parking brake indicator
light in the combined instrument is turned on.
When driving without loosening the parking
brake control handle, the driving computer
screen will prompt "Please release the brake" (if
equipped).
When the parking brake is released, the parking
brake control handle is pulled up slightly and
the lock button at the front end of the handle is
pressed to release the parking brake control
handle.
The parking brake control handle is placed at
the lowest position, the parking brake is
released and the parking brake indicator light in
the combined instrument is extinguished.
Warning
●In order to prevent accidental movement
of vehicles, after parking, the parking
brake handle should be tightened, and the
shift handle should be placed in the "P"
gear (automatic transmission).
●When the parking brake is released, the
control handle of the parking brake must
be completely loosened. If not, the rear
brake will be overheated and the braking
efficiency will be reduced. In addition, it
may also lead to the brake lining of the
rear wheel wearing too fast.
●The parking brake handle should not be
used for braking when the vehicle is
running, because the parking brake only
brakes the rear wheel, the braking
distance is much longer, and it is easy to
fling the tail, which can easily lead to
Electronic parking brake system
（EPB）*
Manual electronic parking
When the vehicle is in a static state and the
start/stop button is in the "RUN" mode, the
electronic parking brake can be applied by
pulling the electronic parking switch button
upward
along the arrow direction to
prevent the car from slipping.
Automatic electronic parking: When the vehicle
is in an arbitrary gear state and the start/stop
button is placed in the "OFF" mode, the vehicle
parks automatically.
To Next Page
Loading...
Need help?
General
