Brake system 153
D50
3
Driving guide
Secondary application of electronic parking:
In some special cases, by placing the start/stop
button in the "RUN" mode and pulling the
electronic parking switch button upward along
the arrow direction for 3 seconds in the case of
parking, the brake
caliper can be
clamped twice.
Manual release of electronic parking:
When the start/stop button is in "RUN" mode,
the electronic parking brake can be released by
pressing the brake pedal and pushing down the
electronic parking switch button along the arrow
direction.
Notice
●If parked on a larger ramp, the
electronic parking switch can be pulled up
again after parking is completed to ensure
maximum parking strength.
●If the brake pedal is not pushed down,
the electronic parking switch will not be
released. The combin
ed instrument
display indicates "Please press on the
brake to release the electronic parking"
(if equipped).
●Electronic parking should be applied
before the shift rod is placed in the "P"
gear position after the automatic gear is
stopped.
●In some special cases, if the electronic
parking brake is not needed for parking,
the electronic parking switch can be
pushed down before closing the start/stop
button, and the power supply of the whole
vehicle can be kept for more than 3
seconds, then the v
ehicle will not be
parking brake.
Automatic Removal of Electronic Parking
First, make sure the door is closed and the
driver fastens his seat belt. Pull P or N gear into
D or R gear, press the accelerator pedal, and the
electronic parking will be released
automatically.
。
Notice
●Make sure that the driver's seat belt is
fastened, otherwise the automatic release
function of electronic parking cannot be
To Next Page
Loading...
Need help?
General
