238 Emergency traction.
D50
5
Emergency handling
Emergency traction.
When vehicles need traction, they must obey
traffic laws. Improper traction equipment can
damage the vehicle. In order to ensure the
correct traction method and protect the vehicle
from accidental damage, it is recommended to
ask professional road rescue person and vehicle
to track it. In the traction, the driver and rescue
person should pay attention to the following
matters
●Make sure the transmission, steering and
transmission system are in working condition
before traction. If any system is damaged, then
must use flatbed rescue vehicle to transfer the
vehicle or lift the front wheels for traction
●“ACC” Make the START/STOP button at
ACC position.
●Fix a tow rope or chain to the trail hook
Vehicle front traction
If the vehicle is towed when driving (front)
wheel to be towed, for manual transmission,
should be in neutral gear; for automatic
transmission, the gear should be placed in "N"
gear, and the speed should not be higher than
50km/h, the distance should not exceed 50km
●When towing a vehicle, turn on the hazard
warning light switch
●Release the parking brake.
Towing of vehicle from front
The drawing position of the front of the vehicle
is shown in the figure.
The operation as follows:
Remove the front tractor hook and wheel nut
wrench from the tool box in the trunk
Use a screwdriver to open the cover plate, then
carefully remove the cover plate.
Screw the front tow hook into the threaded hole
on the right side of the front bumper clockwise
and tighten it.
Do not jerk on the hook. Apply a steady and
even force
To Next Page
Loading...
Need help?
General
