Brake system 151
D50
3
Driving guide
In order to ensure safety, a safer driving method
should be used, and greater force should be
exerted on the brake pedal when braking to tow
the faulty vehicle to the service station or drive
at low speed to the nearest special maintenance
station.
Warning
●When the vehicle completely loses its
brake, do not drive forcibly. At this time,
stop safely by the side, contact the special
service station and wait for rescue.
8. Brake overheating
When the brake is not needed, do not put the
foot on the brake pedal to make the brake "slip",
which will lead to overheating of the brake,
reduce the braking efficiency, extend the
braking distance and increase the wear of the
brake lining and brake disc.
Brake wear indicator*
The brake lining block is equipped with wear
sound indicator. If you hear a sharp scream or
scratch when you press on the brake during
driving, it indicates that the brake lining block
needs to be replaced. (Brake lining wear cue
sound is different from brake extrusion, usually
brake extrusion sound is caused by dust on the
brake surface when braking slightly)
Hydraulic Braking System
Hydraulic brake system transfers hydraulic
pressure to break through double circuit. If one
of the loops fails, the other will continue to
work. At this time, under the condition of
ensuring safety, drive to the nearest special
service station at low speed for maintenance. In
this state, braking requires greater force on the
pedal.
Brake system fault alarm lamp
If the brake system fault alarm lamp is on
during the driving process, it indicates that the
brake system is faulty. At this time, it is
necessary to check the brake fluid level. If the
brake fluid level is normal, there are other faults
in the brake system. At this point, in order to
ensure safety, pull over immed
iately and contact
Special service station for inspection and
maintenance.
To Next Page
Loading...
Need help?
General
