228 Fuse replacement
D50
5
Emergency handling
A fuse extractor on the fuse box body can be
used to pull out the fuse.
Pull out the fuse corresponding to the
malfunctioned electrical equipment and check.
Check the wire in the fuse to see if it has burnt,
If a fuse has burnt (the fuse shown here has
been disconnected), replace it with a spare fuse
with the same or lower amperage value.
If the replaced fuse with the same rating is burnt
again in a short time, it indicates that there may
be a serious electrical fault in the vehicle. At
this time should prohibit the use of faulty
electrical equipment, keep the burnt fuse at its
place, and contact BAIC service station for
maintenance.
Tips
●If the vehicle cannot move because there
is no spare fuse to replace, a fuse with the
same or lower amperage value can be
removed from another circuit to replace
the fuse, but it must be confirmed that the
use of the electrical equipment will not
affect the driving, such as cigarette lighter
Notice
●If you replace a burnt fuse with a lower
ampere-value spare fuse, replace it with
the correct rated fuse as soon as possible
To Next Page
Loading...
Need help?
General
