236 Jumper start
D50
5
Emergency handling
When operation the jumper start, the positive
pole must be connected firstly, after then
connect the negative pole.
1. Turn off the START/STOP button.
Connect one end of the red cable -1- to the
positive pole (+) of the power off battery "A".
The other end -2- is connected to the positive
pole (+) of power supply battery "B".
Connect one end of the black cable -3- to the
negative pole (-) of the power supply battery
"B" and the other end -4- to the engine block of
battery "A" or the metal part fixed to the engine
block
Start a vehicle with a power supply battery, idle
it, and then start a vehicle without a power
supply battery. After the vehicle starts, it needs
to run for a period of time so that the generator
can charge the battery.
Notice
●When connecting or disconnecting the
jumper cable, com
disassemble one jumper cable, and then
connect or disassemble another jumper
cable, do not cause short circuit.
●When removing the jumper cable, the
engine should be idled to prevent stalling
To Next Page
Loading...
