Instrument and control system 57
D50
2
Operation system and specification
The tire pressure monitoring alarm light flashes
at the Hz frequency for 60 seconds, then
remains bright and beeps 5 times. When the
signal of the tire pressure monitoring system is
lost, the display has no tire pressure display, and
the tire pressure monitoring alarm lamp flashes
at a frequency of 1Hz
Tire pressure reset:
When the tire pressure display is abnormal, the
user can reset the tire pressure system by
operating the adjustment lever of the meter.
1.Long press (≥1.5 seconds) This button, the tire
pressure display on the meter display and the
tire pressure monitoring alarm light on the dial
will start to flash at 0.5Hz frequency at the same
time;
2 .Short press this button, which sends a reset
request to the tire pressure system. The tire
pressure on the instrument display screen is not
displayed, and the tire pressure monitoring
alarm light on the dial will keep flashing at a
frequency of 0.5 Hz;
3. After about 4 seconds, the tire pressure
display on the meter display and the tire
pressure monitoring alarm light on the dial will
stop flashing. If the tire pressure display on the
meter display and the tire pressure monitoring
alarm light on the dial are off, then the tire
pressure reset is successful, and the tire pressure
is normal; if the flashing stops, the tire pressure
display on the meter display still in an alarming
state, or the tire pressure monitoring alarm light
flashes or goes out, indicating that the tire
pressure system is faulty at this time, should go
to the repair shop for maintenance.
The clock display
Clock display the current time. After receiving
the time signal form the video host, the time is
displayed.
To Next Page
Loading...
Need help?
General
