Instrument and control system 75
D50
2
Operation system and specification
Warning
●When the speed is km5km/h, if any door
is opened, an audible alarm will
Electric Power Steering System (EPS) Fault
Warning Light EZI ( Ye ll o w)
When the start/stop button is in the “RUN”
mode, this light illuminates the self-test and
goes out after the self-test.
If it does not go out after the self-test or lights
up during driving, it indicates that the EPS
system is faulty. The alarm pop- up window
displays “Please check EPS” with three beeps
(7-inch meter).
Idle start and stop system work indicator (only
for some models) D (green)*
When the start/stop button is in the “RUN”
mode this light illuminates the self-test and goes
out after the self-test.
This light indicates the start-stop system status
and is illuminated when the vehicle enters the
idle stop mode. Idle start / stop system not
working/fault indicator (only for some models)
D (yellow)*
When the start/stop button is in the “RUN”
mode, this light illuminates the self-test and
goes out after the self-test.
This light is on when the idle start/stop function
is turned off or the idle start/stop system is
faulty.
Lane departure warning system work indicator
(only for some models) D (green)*
This indicator indicates that the lane departure
warning system is on. This light is on when the
lane departure warning system is normally
turned on.
Lane departure warning system fault alarm
indicator (only for some type vehicle)
(red)
This indicator indicates deviates from the
warning system’s fault condition. This light
illuminates when the lane departure warning
system is not working properly. The alarm pop-
up displays “Blank Departure Warning System
Fault” with three beeps (7-inch meter).
Blind area monitoring system work indicator
(only for some models) (green)*
This indicator indicates that the blind zone
monitoring system is on. This light illuminates
when the blind zone monitoring system started.
Blind area monitoring system work indicator
(only for some models) (red)*
This indicator indicates the blind zone
monitoring system fault status. This light
illuminates when the blind zone monitoring
system is not working properly. The alarm
pop-up displays “Blind Point Monitoring
System Fault” with three beeps (7-inch meter).
To Next Page
Loading...
Need help?
General
