www.bal dormotion.com
5-6 Operation MN1901
3. In the Select Controller dialog, go to the drop down box near the top and select the PC serial
port to which the drive is connected. If you are unsure which PC serial port is connected to
the drive, select Scan all serial ports.
Click Scan to search for the MintDrive
II
.
When the search is complete, click on MintDrive
II
in the list to select it, and click the Select
button.
This check box is al ready sel ected for you. When you
click Select, it means that the Commissioning Wizard
will start automatically.
Note: If the MintDrive
II
is not listed, check the serial lead between the MintDrive
II
and
the PC and that the MintDrive
II
is powered correctly . Click Scan to re- scan the
ports.
To Next Page
Loading...
Need help?
General
