B&C CL 7685 - Operating the System; Pre-Operation Check

B&C Electronics CL 7685
Operator’s Manual - Rev. C - 05/05
- 17 –
3.3 OPERATING THE SYSTEM
Pre-operation check
The system's controls and indicators are all located on the front panel. (See Fig. 1).
The meter has a LCD display 1 indicating that unit is on.
The cards of the controllers are adjusted at the factory.
If sensors and probes have been connected correctly, as described in the above sections, the system
should function correctly needing only the start up and the parameters calibrations as described in the
following section.